English 3
PARTS
1. Thermostat
2. Heat/ Fan select switch
3. Indicator light
4. Handle
5. Air outlet
(always faces front)
6. Air inlet
20. Do not let cord hang over edge of table or
counter, or touch hot surfaces, including the
stove.
21. Do not place the appliance on or near hot gas,
22. Do not use the appliance for other than its
intended use.
23. Do not use the device with wet or moist hands
24. Always attach plug to appliance and check that
the switch is on “0” before plugging cord into
wall outlet.
25. Check if the socket and the plug are not dam-
aged and put the plug well in the socket.
27. Be sure that there is enough space for the
fan heater while operating, at least 24 inches
around the appliance, and 4 feet in front of the
air outlet.
28. Don’t cover the fan heater at any time when
operating.
29. Do not hang on the wall.
31. Do not put the appliance below an electrical
socket.
from the heater.
33. In case of malfunction or abnormal operation,
don’t attempt to open or repair the appliance at
home, take the heater to an appointed service
agent for inspection and repair.
OVERHEAT SECURITY SYSTEM
To avoid risk to individuals or damage to internal
components, the fan heater has a security
system. If overheating occurs:
1. Turn the Heat/Fan Select switch to “O” position,
and the Thermostat Switch to minimal position.
Remove the plug from the socket.
and inlet, and if the appliance is placed in the
right position.
3. Let the fan heater cool down for 8 to 10 minutes
before switching it on again.
4. Plug in the appliance and switch it on. If the
appliance can’t operate normally, remove the
plug immediately from the socket and have
the fan heater serviced by an appointed service
technician only.
1
3
5
6
4
2
This unit employs a safety tip-over protection circuit.
If for any reason the heater falls over or is knocked
over, a pressure-sensitive switch at the bottom of the
unit will activate and cut off power to the heater.
Once the heater is repositioned in an upright
position on a flat surface, the tip-over switch will
be de-activated and the unit will begin to function
again.
TIP OVER PROTECTION CIRCUIT
SAVE THESE
INSTRUCTIONS
HOUSEHOLD
USE ONLY
