Impex MARCY MWB-4300, Руководство пользователя

Страница: 16 / 33

STEP 8 (See Diagram 8 & Cable Loop Diagram)
A.) Un-install the M10 x 1 1/8” Allen Bolt (#104) and M10 Aircraft Nut (#86) on the U-shaped
Connector on one end of the 229” Cable (41). Remove the U-shaped Connector, Big
Washer, and Ball Stopper from the Cable.
B.) Insert the end of Cable through the left Cross-over Swivel Pulley Bracket (#99). Attach a
Pulley (#57) to the Swivel Bracket and secure it with one M10 x 1 ¾” Allen Bolt (#69), two Ø
¾” Washers (#66), and one M10 Aircraft Nut (#86). Draw the Cable over the Pulley and pull
it towards the back of the machine.
C.) Draw the Cable along the Left Upper Frame (#94) to the opening on the rear of the Frame.
Drop the cable through the opening.
D.) Attach a Pulley to the opening. Secure it with one M10 x 2 ½” Allen Bolt (#70), two Pulley
Bushings (#62), and one M10 Aircraft Nut (#86). Draw the Cable around the Pulley then
downward.
E.) Attach two Small Pulleys (#103) to the Triple Floating Pulley Bracket (#96). Secure them to
the Bracket with one M10 x 2 ¾” Allen Bolt (#105), two Ø ¾” Washers (#66), and one M10
Aircraft Nut (#86).
F.) Draw the Cable around the back Pulley then upward to the bracket underneath the Rear
Upper Frame (#9). Install a Single Small Pulley Bracket (#98) to the bottom of Rear Upper
Frame (#9). Secure it with one M10 x 1” Allen Bolt (#68), two Ø ¾” Washers (#66), and one
M10 Aircraft Nut (#86). Install a Small Pulley to the Single Small Pulley Bracket.
G.) Draw the Cable around the Small Pulley then downward to the Triple Floating Pulley
Bracket. Draw the Cable around the front Small Pulley then upward to the opening on the
rear of Right Upper Frame (#95). Let the Triple Floating Pulley Bracket hanging for now.
H.) Install a Pulley to the opening. Draw the Cable over the Pulley along the top of the Right
Upper Frame through the cable sleeve to the right Cross-over Swivel Pulley Bracket. Install
a Pulley to the Bracket.
I.) Re-install the Ball Stopper, Big Washer and the U-shaped Connector previously removed in
Procedure A above. Secure it with the M10 x 1 1/8” Allen Bolt (#104) and M10 Aircraft Nut
(#86).
J.) Connect a Single Handle Strap (#90) to each end of the Cable with a C-clip (#61).
K.) When using the Lat Bar, remove one of the Strap and connect the Lat Bar to end of the
Cable with a Short Chain (#63) and two C-clips (#61).
15