B. Cleaning and Lubrication:
a. Use a clean towel, slide it between the running belt and deck of the treadmill at the motor
end, so that one end of the towel hangs over each side of the machine.
b. Hold both ends of the towel, pull it back and forth under the belt, and move toward the
other end of the running belt; make sure the belt stay in place.
c. When you reach the rear roller, hold the belt down and move the towel toward the front of
the treadmill, repeat these steps a few more time. This will clean both the belt and
treadmill deck.
d. Take the lubricant and apply to the treadmill bed.
e. Walk on the treadmill for 2 minutes at about 5 km/h in order spread the lubricant evenly.
f. Belt slippage may occurred for a short time. If it persists, adjust the running belt tension
according to the owner's manual (adjust belt tension). Do not over-tighten, as this will
decrease the life of the belt. Always make sure the belt is not over-tightened.
g. If you are not certain of any procedure or lack of correct tools, please contact your dealer.
C. Silicone Lubricant
Silicon Lubricant Warning
－－
KEEP OUT OF REACH OF CHILDREN !
Ÿ
If swallowed or applied directly on face, seek medical advice immediately.
Ÿ
If spilt, clean up immediately, as slippage hazard may result.
a. Apply 2 cc of silicon lubricant on each lubrication point (the lubrication point situated
under the running belt, which is 10 cm from sides of the belt and 30 cm from the near end
of motor cover). Apply on both left and right sides of the belt.
b. Walk on the treadmill for 2 minutes at about 5 km/h in order spread the lubricant evenly.
** Note: This product may cause danger if used otherwise than strictly in accordance with
the directions for its use.
This product is sold only subject to these conditions and upon the basis that it is used solely
at the purchaser's own risk and the manufacturers and distributors hereby exclude
themselves from all liability in relation to this product howsoever arising.
4
Содержание iT 4500
Страница 1: ...USER MANUAL...
