Cheetah KAC Camera User Manual | Camera Link (CLF) Interface
October 1, 2019
Page
83
of
135
Rev 7.2
LUT Settings:
Enable
: – enables the usage of the selected Look-Up Table (LUT).
LUT Select
– selects which of the two supported LUTs will be used. By default, LUT #1
is factory programmed with standard Gamma of 0.45. LUT #1 and LUT #2 can be
reprogrammed by the user.
Corrections:
DPC
– enables Defective Pixel Correction (DPC). Each camera comes with a built-in
Defective Pixel Map (DPM) to correct for defective pixels. The user can upload a
custom DPM.
HPC
– enables Hot Pixel Correction (HPC). Each camera comes with a built-in Hot Pixel
Map (HPM) to correct for hot pixels. The user can upload a custom HPM
Image Flip:
H. Mirror
-- Mirrors the Horizontal output video when checked ‘On’.
V. Mirror
-- Mirrors the Vertical output video when checked ‘On’
Test Mode:
Test Patterns
– the camera can output eight test patterns:
Off
– test mode is off.
H Ramp
– displays a stationary horizontal ramp image.
V Ramp
– displays a stationary vertical ramp image.
H Ramp move
– displays a moving horizontal ramp image.
V Ramp move
– displays a moving vertical ramp image.
Crosshair
– superimposes a cross, located in the center of the CMOS images.
4.7.6 Color
This window sets the corrections for the primary R G B colors. In addition, this window
sets the White balance mode and displays the calculated white balance coefficients. This
window is disabled for monochrome cameras.
