PPI-109-REV. B IMPCO Technologies Inc. April, 2008
D. Secondary Lever Height Gauge (G2-2):
The secondary lever height gauge is actually two gauges in one. One side provides the secondary
lever heights for the Model E & Model L regulators and the other side has the mounting hole
templates for the Model J, L, EV & E regulators and the Model VFF lockoff.
Secondary Lever Height Gauge (G2-2)
To use as a mounting-hole template:
The left hole (under the word “COMMON”) is common hole when using the gauge as a mounting
template. Locate the hole under the model number of the regulator or lockoff you are using for the
other hole.
To use as secondary lever height gauge:
•
Model
E:
With the secondary chamber cover off, lay the gauge on the regulator body and slide the slot
labeled “E” over the secondary lever pin as illustrated. If the pin will not easily slide into the slot
or lifts the gauge up off of the body, remove and carefully bend the lever until it slides in without
force and does not lift the gauge.
NOTE:
Bending the lever in place may result in damage to the seat.
Model “E” Regulator
3030 South Susan St. Page 9 of 12
Santa Ana, CA 92704
www.impcotechnologies.com