5
INSERT
the crank shaft into the crank gear
housing on the right leg. Affix the crank shaft to
the top arm using three (3) M6 machine bolts.
6
ATTACH CRANK TO ARM
FOR THIS STEP:
crank gear housing
crank shaft
EXTEND
the base to the appropriate width, so
that the holes in the base are aligned with the recessed nuts
on the table top. Secure the base to the table top with the
appropriate machine screws. You may now tighten the top
arm screws from Step 3.
5
ATTACH BASE TO TABLE TOP
FOR THIS STEP:
R
L
x3
x3
use the smaller hex wrench for the
set screws
not provided
the four (4) set screws
are located on the
bottom of the crossbars
