3
the feet are compatible with
both the right or left leg
ASSEMBLY INSTRUCTIONS
CLEAR
a good-sized area to lay out all components
and assemble the desk. Lay the table top down on the floor,
laminate side down. If not on carpet, we recommend
placing a soft blanket down first in order to protect the
table top surface. Make sure the entire area is clear of any
loose screws or debris, to avoid scratching the laminated
surface. Alternatively, this can all be done on top of another
table rather than on the floor. Be careful not to slide the
table top while upside-down, to protect the laminate.
THE ELLURE
base is designed to work with any table top,
though assembly is easiest when using a genuine ELLURE
table top. ELLURE table tops include threaded insert nuts
that remove any confusion as to where to drill, the bit size
to use, or how deep to drill. These recessed nuts also extend
the life of the product, by preventing degradation of the
wood fibers from over-tightening and from removing and
reinstalling wood screws too many times.
1
PREPARE FOR ASSEMBLY
FOR THIS STEP:
ATTACH
one foot to each lifting leg with four (4) M6
machine bolts provided.
SET
the right and left lifting legs upside down on the table.
Ensure they are positioned correctly on the table top,
referring to the diagram below. The right lifting leg will
have the crank gear housing attached. Insert one end of
each crossbar into the opposing ends of the lifting legs,
connecting the two legs together.
2
ATTACH FEET AND SET CROSSBAR
IN LEGS
FOR THIS STEP:
the right lifting leg
has the crank shaft
housing module
CAUTION!
R
L
