ELECTRICAL SAFETY
• CAUTION: Never remove any cover without first
disconnecting AC power.
• To reduce the risk of an electrical shock, disconnect your
treadmill from the electrical outlet prior to any cleaning,
lubrication or service work.
• Never use a ground fault circuit interrupt (GFCI) wall outlet
with this treadmill. As with any appliance with a large motor,
the GFCI will trip often. Route the power cord away from any
moving part of the treadmill including the transportation
wheels.
• To reduce the risk of burns, fire or electric shock, be sure
to install your treadmill where it will have good access to a
110-volt, 10-amp grounded outlet, with only the treadmill
plugged into the circuit.
• Do not use an extension cord unless it’s a 14 AWG cord, or
better – with only one (1) outlet on the end. The outlet must
be a three-prong, grounded type. The treadmill should be
the only appliance in the circuit to which it is connected.
• Never operate the treadmill if it has a damaged cord or plug.
• Do not attempt to disable the grounding plug by using
improper adaptors or extension cords, or in any way attempt
to modify the cord set. A serious shock or fire hazard may
result along with electronics malfunctions.
• If voltage varies by 10 percent (10%) or more, the
performance of your treadmill may be affected. Such
conditions are not covered under your warranty. If you
suspect the voltage is low, contact your local power
company or a licensed electrician for proper testing/
evaluation.
TREADMILL SITING AND INSTALLATION
• Do not operate treadmill on a deeply padded, plush or shag
carpet. Damage to both carpet and the treadmill may occur.
• Provide a minimum clearance of 1m (40”) behind the treadmill
and 1/2m (20”) to the left and ride sides of the treadmill.
Comply with local fire codes for any additional clearance
instructions, and never block access to fire safety equipment.
• Use a level to make sure that the treadmill is perfectly
horizontal, as most floors are slightly uneven. Use the
adjustable leveling feet on the treadmill to ensure that all four
corners of the unit are solidly on the floor, and no corner is
“high sided.” Making sure the treadmill is perfectly horizontal
is key to avoiding undue torqueing forces on the frame, which
can cause the belt to move out of position, generate squeaks
or scraping noises when walking on the belt, reduce the life
expectancy of key components, and/or void the warranty.
• Keep all cords away from heated surfaces.
• Do not operate in the vicinity of where aerosol products are
being used or where oxygen is being administered. Sparks
from the motor may ignite may ignite a highly gaseous
environment.
• Never expose this treadmill to rain or moisture. This product is
NOT designed for use outdoors, near a pool or spa, or in any
other high-humidity environment.
• The treadmill’s specified environmental operating range is:
• Temperature: 50° to 95° Fahrenheit (10° to 35 °Celsius)
• Maximum Humidity: 80% non-condensing (no water
drops forming on surfaces)
3
GETTING STARTED
The Ready-Set-Go section of this manual will get you upright and walking in no time, but first we need to review some important
safety information to ensure that your experience is a positive one and that your equipment always performs at peak efficiency. The
vast majority of treadmill support calls can be attributed to a failure to properly level the treadmill or to keep it properly lubricated
and clean. To ensure that your treadmill continues to work trouble-free for many years, and your warranty coverage remains intact,
please pay particular attention to the instructions in this manual pertaining to installation and regular maintenance. Please note
that failure to follow the instructions in this manual may void your warranty.
IMPORTANT SAFETY INSTRUCTIONS
Please read all instructions carefully before using this treadmill.
