4
ATTACH FEET AND SET
CROSSBAR IN LEGS
the feet are compatible with
both the right or left leg
ASSEMBLY INSTRUCTIONS
CLEAR
a good-sized area to lay out all components
and assemble the desk. Lay the table top down on the floor,
laminate side down. If not on carpet, we recommend
placing a soft blanket down first in order to protect the
table top surface. Make sure the entire area is clear of any
loose screws or debris, to avoid scratching the laminated
surface. Alternatively, this can all be done on top of another
table rather than on the floor. Be careful not to slide the
table top while upside-down, to protect the laminate.
THE
base is designed to work with Omega Denali desk
tops which include threaded insert nuts that remove
any confusion or need to drill, the bit size to use, or how
deep to drill. These recessed nuts also extend the life of
the product, by preventing degradation of the wood fibers
from over-tightening and from removing and reinstalling
wood screws too many times.
1
PREPARE FOR ASSEMBLY
FOR THIS STEP
ATTACH
one foot to each lifting leg with four (4) M6
machine bolts provided.
SET
the right and left lifting legs upside down on the table.
Ensure they are positioned correctly on the table top,
referring to the diagram below. The right lifting leg will
have the crank gear housing attached. Insert one end of
each crossbar into the opposing ends of the lifting legs,
connecting the two legs together.
2
FOR THIS STEP
the right lifting leg
has the crank shaft
housing module
CAUTION!
R
L