IMKO TRIME-PICO 32, Руководство пользователя

Страница: 44 / 48

Manual TRIME_PICO64-32 Version 2_0 2017-05-30
Page 44
1301 Write file error in Test Check file path and try it again. If failed,
restart PICO-CONFIG.
4001-4002,
4101-4106,4201
Read file or write file errors Check the files and try again.
4301-4303 Intenal calculating errors Restart PICO-CONFIG and try
again.Otherwise contact IMKO.
13.2 PICO Errors (Firmware errors). The errors come from the firmware, from
1 to 255.
Code Explanation Measurement
1-19 The serial communication errors due to
incorrect telegram, baud rate, timing etc. Power off, power on PICO and try it again. Otherwise contact
IMKO.
20-39 incorrect command number, command
right or command parameters. Power off, power on PICO and try it again. Otherwise contact
IMKO.
40-49 EEPROM is defect Power off, power on PICO and try it again. Otherwise contact
IMKO.
50-59 ASIC is defect Power off, power on PICO and try it again. Otherwise contact
IMKO.
60 Power voltage is too low Check power voltage of PICO, it is minimal 6V.
100 TDR measurement parameter is incorrectly
set or the material conductivity is too high. Adjust the TDR measurement parameters or contact IMKO
101 TDR measurement parameter is incorrectly
set Adjust the TDR measurement parameters or contact IMKO
102 ASIC is defect Power off, power on PICO and try it again. Otherwise contact
IMKO.
103 EC parameter is incorrectly set. Power off, power on PICO and try it again. Otherwise contact
IMKO.
105 Tp is out of range for the standard calibra-
tion polynomial. Check if PICO is inserted in the measured material correctly.
108 TDR measurement parameter is incorrectly
set or the material conductivity is too high. Adjust the TDR measurement parameters or contact IMKO
120-129 Internal chip problem Power off, power on PICO and try it again. Otherwise contact
IMKO.
130-199 Internal errors Contact IMKO
200-254 Reserved
255 The data transmission is not finished.