IMI Onyx NX-10, Руководство по эксплуатации

Страница: 15 / 38

ONYX OPERATION MANUAL 9
8. Operation of ONYX
Units of Measurement
ONYX will display detected radiation levels in CPM -­‐
Counts Per Minute and either μSv/hr (microSieverts Per
Hour), or mR/hr (milliRoentgens Per Hour).
Before Using Your ONYX
Charge your ONYX
Depending on the charger used, this will take 1 to 2
hours if the battery is fully depleted.
You may charge your ONYX from any standard
computer USB port or from a wall-­‐wart or dedicated
USB Charger. When you connect a powered micro-­‐USB
connector to your ONYX, it will perform a soft reset and
self-­‐test. You will see the startup screen, showing your
firmware version number, before settling-­‐in to begin
counting again.
You will also see a charge indicator on the battery icon
while ONYX is being charged.
Using Your ONYX
On the back of the ONYX, slide the Mode Switch down
to the “Un-­‐Lock” position . Once the processor re-­‐
initializes, the OLED display will illuminate and ONYX
will immediately begin to count and measure radiation
while displaying the
Current Readings on-­‐screen. The