Caution!
There are no user serviceable parts inside the unit. Do not open the housing or attempt any
repairs yourself. If exceptional problem happen, please contact related after-sale department
or manufacturer.
Any damage that cased by violating this manual is out of insurance, our company will not take
the responsibility.
Section 2. Set Up
Installation
Controlling Board
Machine connection
Installation
This machine should be mounted through the screw holes of truss. Safety wire is a must
to fix fixture well. Make sure truss and safety wire have strong load capacity to bear 3 times
weight than fixture at least.
This machine should be installed by qualified technician.
3
4
Safety Instruction
s
Please conserve this manual as operation guidance. If you sell this product to other user,
please make sure that they also receive this user manual.
Always make sure that you are connecting to the proper voltage and the line voltage not
higher than stated on the decal or rear panel of the fixture.
This lighting is intended to indoor use only. To prevent risk of fire or shock, do not expose
fixture to rain or moisture. Make sure there are no flammable, explosive or corrosive
materials surrounded in 0.5meters while operating.
The unit must be installed in a location with adequate ventilation, at least 1m away from
adjacent surfaces. Be sure that no ventilation slots are blocked.
Fixture may carry high heat, do not aim at objective exceeding 2 minutes.
Safe wire should be used to install machine. Bearing of safe wire should be 3 times of the
machine weight.
Always disconnect from the power source before servicing or replacing fuse/lamp and be
sure to replace with same fuse/lamp size and type. Cut off power before moving, repairing
and cleaning the machine.
To avoid electric shock, all fixtures must be connected to circuits with a suitable ground.
Always secure fixture using a safety chain and carrying handles. Never carry the fixture by
its cord.
Do not operate at ambient temperatures higher than
40°C (104°F).
In case of failure or misfunction occurred, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center. Buy the
same spare parts/components from manufacturer directly.
Make sure the power cord is never crimped or damaged.
Avoid direct eye exposure to the light source while it is on.
Do not power on and power off the fixture in a short time.
When use DMX controller, please make sure that there is no interference sources (e.g.
intercom, high frequency radio waves and radiation source.
For your safe
，
please read this user manual carefully before turn on
the fixture. This machine should be operated by qualified engineer
！
