15
English
1 . Use a mounting bracket (3) to fasten the
spotlight, e . g . by means of a stable mount-
ing screw or a support for lighting units
(C hook) on a crossbar .
To align the spotlight, loosen the two set-
screws (5) on the mounting bracket . Tilt the
spotlight as desired and then firmly retighten
the setscrews .
2 . Alternatively, set up the spotlight on its own:
Fold out the mounting brackets underneath
the spotlight and use them as stands . Then
firmly tighten the setscrews .
5 Setting into Operation
WARNING
To prevent damage to your eyes,
never look directly into the light
source for any length of time .
Please note that fast changes
in lighting may trigger epileptic
seizures with photosensitive persons or persons
with epilepsy!
Connect the mains cable supplied to the mains
jack POWER IN (1) and then to a mains socket
(230 V/ 50 Hz) . After that, the spotlight is ready
for use: It can either be operated by means of
a DMX light controller (
☞
chapter 8) or will
automatically run the control program selected
(
☞
chapter 7) . To switch off the spotlight, dis-
connect the mains plug from the socket .
Caution:
Never connect the unit to the mains voltage
via a dimmer!
For power supply of another spotlight, the mains
output jack POWER OUT (9) can be used if the
total power consumption does not exceed the
rated power of the fuse in the fuse support (2)
(
☞
type label) . For connection, the mains ex-
tension cable AAC-170 / SW is available, for ex-
ample . Thus, multiple spotlights PARL-12RGBW
can be interconnected .
6 Operation
Select the operating mode and the different
functions via the menu, using the buttons
MENU, UP, DOWN and ENTER (7) . Please refer
to chapter 10 .2 for the menu structure . Many
functions can also be directly selected by means
of the remote control supplied (fig . 2) . More
information on how to operate the spotlight by
means of a DMX light controller can be found
in chapter 8 .
6.1 Remote control
1) The remote control is supplied with the bat-
teries inserted . An insulating foil between the
batteries and the battery contacts prevents
the batteries from being discharged . Prior
to the first operation, remove the foil from
the battery support on the rear side of the
remote control .
2) When pressing a button, direct the infrared
remote control to the front side of the spot-
light, making sure that no obstacles are be-
tween the remote control and the spotlight .
Please refer to chapter 1 .1 for the func-
tions of the remote control .
To protect the spotlight against inadvertent
operation, switch off infrared reception via
the menu of the spotlight (
☞
chapter 9 .1) .
3) If the range of the remote control decreases,
replace the batteries: On the rear side of the
remote control, push the small latch with the
groove to the right and pull out the battery
support at the same time .
1.
2.
➂
Pulling out the battery support
Two 1 .5 V button cells of the type LR54 are
required . Observe the right polarity when
inserting the batteries (
☞
indications
⊕
and
⊖
in the battery support) .
If the remote control is not to be used for
a longer period of time, remove the batteries
to prevent damage to the remote control due
to battery leakage .
Never put discharged batteries in the
household waste . To protect the envi-
ronment, always take them to a special
waste disposal, e . g . collection container
at your retailer .
Содержание 38.6890
Страница 67: ...67 Polski ...
