IMG STAGE LINE 38.6890, Инструкция по эксплуатации

Страница: 16 / 71

16
English
6.2 Operation by means of the menu
To make settings by means of the menu, use
the buttons MENU, UP, DOWN and ENTER (7) .
1) Press the button MENU repeatedly until
the display does not change anymore: The
top menu level (main menu) has then been
reached (
☞
chapter 10 .2, left side of the
figure) .
2) Use the button UP or DOWN to select the
menu item desired .
3) Press the button ENTER (if required, twice) .
The display will indicate the current setting
of the menu item selected .
4) Use the button UP or DOWN to change the
setting .
5) If submenu items are available: Press the but-
ton ENTER to call up the submenu items, and
then use the button UP or DOWN to change
their settings .
6) Press the button ENTER to save a setting .
Thus, a change will be retained even after
the power supply was interrupted .
7) Use the button MENU to go back to a
higher menu level for making further set-
tings (if required, go back to the main menu,
☞
step 1) .
The display will extinguish after a few seconds,
if no button is pressed . It will illuminate again
once a button is pressed .
Make the desired settings for the respective op-
erating mode, observing chapters 7 to 9 .
7 Operation without
DMX Controller
7.1 Colour spotlight and stroboscope
In this mode, the spotlight constantly emits light
of an adjustable colour . In addition, the strobo-
scope function can be activated .
Use the remote control to switch the primary
colours individually on and off: Press the appro-
priate button for white or the primary colour
desired (5/ W = white, 7/ R = red; 8/ G = green,
9/B = blue) . Then use the buttons UP and DOWN
to change the brightness of the colour selected .
Press the button STROBE to activate and deac-
tivate the stroboscope function .
To set the colour mix via the menu of the spot-
light:
1) Call up the menu item
.
will appear on the display .
2) Use the button UP or DOWN to select the
colour to be set ( = red, = green,
= blue, = white), and then press
the button ENTER to confirm .
3) Use the button UP or DOWN to set the
brightness value (0 – 255) of the colour se-
lected, and then press the button ENTER to
save the setting .
4) If desired, change the setting of the strobo-
scope effect: Use the button UP or DOWN
to set the flash frequency between
(permanent light) and (approx . 10 Hz),
and then press the button ENTER to save the
setting .
To make settings for further colours, press the
button MENU (twice) and proceed with step 2 .
Alternatively, select one of 51 predefined col-
ours:
1) Call up the menu item
.
2) Use the button UP or DOWN to select the col-
our desired ( to ), and then press
ENTER to save your selection .
3) If desired, change the setting of the strobo-
scope effect: Use the button UP or DOWN
to set the flash frequency between
(permanent light) and (approx . 10 Hz),
and then press the button ENTER to save the
setting .