4
1.3
Installation
v
Only a qualified technician should perform the machine installation or a suitably trained
person.
Note:
it is dangerous to work on a moving machine and the machine should be off and isolated
before any form of work is performed.
•
Machine should be placed in a well-‐ventilated room, free from dust and excessively
corrosive materials.
•
There should be at least 1,5m space around each side of the machine for convenient
operation and maintenance.
•
Prepare the power supply 380V or 220V/50HZ. Three/Single Phase and neutral, and
connect to an appropriate earth wire.
•
Pneumatic connections should take place as the designated connection. The air should
not be less than 6Bar while the machine is operational. Air should be free of water and
contaminants.
•
The machine should be placed on level ground. After installing the machine, check if the
machine is level by Level Instrument. If not, please adjust the four legs.
•
Check every part of the machine carefully for damage during shipping. Tighten any loose
parts, screws and moving parts.
•
All gearboxes should be checked for sufficient oil.
•
Check all electrical connections for loose wires.
•
Make a test of the machines electrical power and confirm the voltage and earth
continuity. All safety connections relative to your own country should be adhered to.
•
Before operating the machine, please lubricate the following parts: across sealing bearing
and its bearing holes, longitudinal where sealing the parts needs oil.
1.4 Electrical and Pneumatic connections
This machine requires only a single phase connection and earth wire
v
DISCLAIMER
IMC will not be held responsible fir incorrect installation and subsequent failure of the
machine due to any installation procedure not being followed.
