2
•
OAM AH Functions
o
Discovery
o
Link Performance Monitoring
o
Remote Loopback
o
Fault Detection
o
Link Fault
o
Dying Gasp
o
Critical Event
•
OAM CFM (SERVICE-OAM)
o
IEEE 802.1ag Connectivity Fault Management (OAM CFM)
o
OAM CFM Functions
o
Continuity Check
o
Loopback
•
Speed/duplex modes
•
802.1q VLAN
•
Extra tagging with user-defined VLAN tag Ethertype
•
Ethertype 88A8 as defined in 802.1ad
•
Command Line Interface capable (CLI)
•
Telnet
•
Password assignment via CLI, Telnet or iView
²
•
DIP Switch configuration for Modes
•
Bandwidth Limiting
The IE-iMcV-MultiWay can be installed as a standalone CPE device, back to back, or
as a Remote when connected to an iMcV-Giga-FiberLinX-II configured as a Host.
As a CPE device, the IE-iMcV-MultiWay can behave as a remote to an iMcV-Giga-
FiberLinX-II host when:
1) The iMcV-Giga-FiberLinX-II:
•
Is connected via the SFP ports on the IE-iMcV-MultiWay
•
Is configured as a Host
•
Uses firmware version A1 860-00D1 or higher
2) The SNMP card (if present):
•
Uses SNMP firmware version 953-00D0 or higher
3) The IE-iMcV-MultiWay:
•
Uses firmware version 123-00A1 or higher
When using iView
2
, the IE-iMcV-MultiWay can be fully managed without an IP
address using a secure management channel. However, an IP address can be
assigned through iView2 (iConfig view), the CLI or Telnet using the default IP address
of 10.10.10.10.
Содержание IE-iMcV-MultiWay
Страница 1: ...IE iMcV MultiWay Operation Manual ...
Страница 36: ...32 Advanced Select Advanced to reboot the module ...
Страница 45: ...41 Agent Info Select Agent Info to display SNMP agent data ...