IMC Networks AccessEtherLinX, Руководство по эксплуатации

Страница: 9 / 24

5
About Serial Port Configuration
Use the supplied RJ-45 to DB-9 adapter on Downlink Port 4 on the
AccessEtherLinX/4 or Downlink Port 3 on the AccessEtherLinX/3 to allow for serial
port configuration. This adapter uses an IBM-compatible DB-9 serial connector.
To connect the AccessEtherLinX to a terminal/computer, use a straight-through (pin-
to-pin) cable. (If the computer/terminal has a COM port using a connection not
compatible with a DB-9 connector, use the pin connection chart shown belowfor
reference in making a cable.) Make sure the cable length is under 50 feet (15.24 m).
Plug one end of the cable into the DB-9 connector and the other into the appropriate
computer/terminal port. Set the computer/terminal for
VT-100 emulation , with:
38.4K baud , 8 data bits , 1 stop bit , no parity and no flow control .
Serial Adapter Pin Connection
RJ-45 Pin # DB-9 Pin # Function
5 2 Transmit (OUT)
7 3 Receive (IN)
8 5 Ground
1-4, 6 1, 4, 6 - 9 Reserved
Main Configuration Screen
After running through an initial self test, the screen will display: “Press <Enter> for
Device Configuration.” Press Enter to be taken to the main configuration screen.
The Main Configuration screen contains the following:
Saved Values
Displays the changes made during the current session.
•
IP Address (MUST be assigned during initial configuration)
• Subnet Mask (MUST be assigned during initial configuration)
Saved Values. <These values will be active after reboot>
IP Address - 000.000.000.000
Subnet Mask - 000.000.000.000 DHCP is not active
Default Gateway - 000.000.000.000
Server IP Addr - 000.000.000.000
New Prom File -
filename
Current Values. <These values are in use now>
IP Address - 000.000.000.000
Subnet Mask - 000.000.000.000
Default Gateway - 000.000.000.000
Server IP Addr - 000.000.000.000
New Prom File -
filename
Community String: public Access: r/w
Press I to enter new saved parameter values. Press P to change Password.
Press T to enter new Trap Destination. Press K to remove ALL Trap Destinations.
Press C to enter new Community String. Press U to remove ALL Community Strings.
Press E to End session. Type REBOOT to reboot unit. Press D for DHCP On/Off.
Press SpaceBar for additional commands.