IMC Networks AccessEtherLinX, Руководство по эксплуатации

Страница: 17 / 24

13
Note
This screen shows the settings for the AccessEtherLinX/4 and includes information
for the unit’s four downlink ports; the same screen for the AccessEtherLinX/3 will
show information for the unit’s three ports.
Using Telnet
Assign the AccessEtherLinX an IP address before using a Telnet session. All
configuration done via the serial port can also be performed using Telnet. Use only
one Telnet session at a time. Do not use an RS-232 serial session and a Telnet
session at the same time.
About DHCP
The AccessEtherLinX comes with a DHCP client. It is disabled by default. If a DHCP
server is present on the network, the DHCP client will initiate a dialogue with the
server during the boot up sequence. The server will then issue an IP address, Default
Gateway and Subnet mask to the AccessEtherLinX chassis. Once the new IP address
is received, the AccessEtherLinX will reboot so that the new IP address will take
effect. See the About Serial Port Configuration section for more information. If there
is no DHCP server on the network, use iConfig or serial configuration to manually set
the IP addresses.