IMB MB2003D-KS-1509P, Инструкция по эксплуатации

Страница: 19 / 27

15
6.6 Cutter change
1) Remove the two fixing screws ○
2
in the figure above, and take out the cutter device
2) Remove the upper cutter fixing screw ○
5
，Remove the upper cutter, replace the new cutter,
and install the fixing screw ○
5
and tighten；
3) Remove the two retaining screws ○
3
，Remove the lower cutter, replace the new cutter,
and install the fixing screw ○
3
No tightening is required；
4) Adjust the positioning bolt ○
4
，Make the upper and lower cutters in the point contact
state, and then set the screw ○
3
tighten。
○
2
○
3
○
4
○
5