Charging your battery
4
In addition,if your LiPo battery does not feature an XH balance
connector,an adaptor board can be used.For more information,re-
fer to the notice on previous page.
The charge rate of 1.5C is vatiable and is automatically deter-
mined by the charger. When charging a LiPo battery, the charge
rate used is based on the charger’s calculation of the LiPo bat-
tery’s capacity and internal resistance while charging to ensure a
safe charge.When charging NiMH battertes,the charge rate used
is based on capacity too. The charger’s maximum power output is
50 watts,so larger capacity LiPo and NiMH batteres will not charge
at 1.5C,but rather at the 50 watt total output.
The charger features a two hour safety timer.When the charging
process is started,an internal safety timer is automatically started.
If the battery pack malfunctions or fails to peak,the timer will
automatically stop the charging process after 2 hours.This two
hour safety timer should allow enough time to fully charge even
the largest capacity battery packs you might use.
1.Press the Start/Stop/Select button to select the desired battery
type,either LiPo or NiMH,depending on the battery type currentlly
connected.
2.Press and HOLD,then release the Start/Stop/Select button to
start the charging process.The status LED of the battery type you
selected will turn red,indicating the charging process has started.
3.Allow the charger to charge your battery.When the charging
process has completed,the status LED will turn green and an
audible chime will sound.
