Imagine neo adc-3981, Инструкция по установке и эксплуатации

Страница: 41 / 63

ADC-3981 Installation and Operation Manual 27
Chapter 3: Operation
Alarms
ADC-3981 modules provide a default list of four alarms. You can
disable any alarm by modifying the
Alarms parameter in the Setup
section.
When you select
Alarms , all of the active alarms are visible in the
display, below Config (Configurations). If no alarms are active, only
Config appears.
Alarm Synchronization
Alarm synchronization is available for this module if your NEO frame
contains a 3901RES-E resource module that supports the feature. When
active, alarm synchronization ensures that the alarm configuration
settings of card-edge controls and the CCS control software and control
panels are consistent.
If the ADC-3981 module is set for local control, the alarm settings will
appear the same at both the card edge and via CCS, but the settings can
only be changed using the card-edge controls. If the module is set for
remote control, the alarm settings can be changed via both the card edge
and CCS control software and control panels.
Alarm configuration settings undergo DejaView (state recovery)
automatically. This means that when a module is hot-swapped, the
alarm configuration for the new module is updated to the settings of the
module that was previously in that slot. See “State Recovery Parameter
Availability” in this chapter for more information.
Identifying the Cause of an Alarm
To identify the reason for an alarm, select the active alarm, and then
press
Enter . A scrolling message appears on the VFD describing the
cause of the fault.