Imagine DES-3901-S, Инструкция по установке и эксплуатации

Страница: 68 / 79

54 DES-3901-S and DNS-3901-S Installation and Operation Manual
Appendix A: Tree-View Navigation
Navigating the Tree View
To navigate and then view or change a parameter from the Tree View,
follow these steps:
1. Open the front panel of the NEO frame.
2. Press any card-edge control to turn on the VFD display.
The message DES-3901-S or DNS-3901-S will appear as the
banner on the card-edge display.
3. Press the Enter button.
The first two items in the Level One list will appear.
4. Click Nav- (down) on the Nav-/Nav+ switch to view more items in
the Level One list.
5. Select the desired item in the Level One list, and then press Enter .
This leads you to the Level Two list.
6. Repeat steps 3 and 4 to view more items in Levels Two, Three, and
Four.
7. If the parameter is selectable, slide the bar to the desired parameter
using the Nav+/Nav- switch.
OR
Select the desired item in the Level Four list, and then press
Enter .
Once the Level Four parameter is set or viewed, you can leave the
parameter in its current state, or return to the banner. To return to the
DES-3901-S and DNS-3901-S banner, repeatedly press the
Escape
button.
Close the front panel again after you have completed the procedure to
prevent the frame from overheating.
Note
If you do not wish to make
changes to your settings, return
to the previously selected item
in the list, and then press
Escape to move up a level. See
SelPar Adj Mode in the Setup
section at the end of the Tree
View to enable or disable this
delayed adjust mode feature.
Note
After several seconds of
inactivity, a scrolling message
will appear, describing the
purpose of the currently selected
parameter.