Imagine DES-3901-S, Инструкция по установке и эксплуатации

Страница: 25 / 79

DES-3901-S and DNS-3901-S Installation and Operation Manual 11
Chapter 2: Installation and Removal
Setting Jumpers
To alternate between SDI and composite video, outputs 1 and 2 are
jumper-selectable. The two jumpers are located near the back edge of
the front module. (See
Figure 2-6 )
Figure 2-6. Location of Jumpers
Each jumper set consists of three upright pins. In each set, one pin is
marked with a small white triangle. When the pin marked by the
triangle is covered by the jumper, the output is switched to composite
video. When the pin marked by the triangle is not covered, the output is
switched to SDI (see
Figure 2-7 on page 12 ).
The two SDI/CMPST outputs can be separately switched to either SDI
or composite video output as needed.