Chapter 3
Operation
46
Changing Parameter Settings
You can change parameter settings at the card edge. You can change the parameter
settings, view read-only parameters, view alarms, and adjust alarm settings using CCS
software. See the following topics:
Changing Parameter Settings Using Card-Edge Controls
Changing Parameter Settings Using CCS Software
Changing Parameter Settings Using Card-Edge Controls
1
Rotate the hex switch (mode select rotary switch) to
0
.
2
Once the hex switch is set to “0,” toggle the navigation switch up or down to select a bank.
View the two control LEDs next to the navigation toggle switch to see which bank is
currently selected. (See
.)
See
to view the various banks, hex switch positions, and
corresponding parameter options and values.
3
Rotate the hex switch to the parameter number (1 to 9) or letter (A to F) of the option you
want to set.
4
Toggle the navigation switch to select and set the value of the chosen parameter.
5
Do either of the following:
Rotate the hex switch to another parameter number/letter in the current bank, and
then repeat step 4.
Rotate the hex switch to “0” again to select a different bank, and then repeat steps
3 and 4.
Use an available 6800
+
software control option to aid in viewing, setting, and
confirming the parameter value.
Table 3-11
Selected Bank as Indicated by Control LEDs
Bank Number
LED 3
LED 2
LED 1
LED 0
0
Off
Off
Off
Off
1
Off
Off
Off
On
2
Off
Off
On
Off
3
Off
Off
On
On
4
Off
On
Off
Off
5
Off
On
Off
On
6
Off
On
On
Off
7
Off
On
On
On
8
On
Off
Off
Off
9
On
Off
Off
On
A (10)
On
Off
On
Off
B (11)
On
Off
On
On
C (12)
On
On
Off
Off
D (13)
On
On
Off
On
E (14)
On
On
On
Off
F (15)
On
On
On
On
Содержание Selenio 6800 SFS6803+OP+SFS+
