SFS6803
+
and OP
+
SFS
+
Installation and Operation Manual
47
Recalling Factory Default Parameter Settings
on page 49 describes all of the parameter settings
for SFS6803
+
and OP
+
SFS
+
modules, including the original factory defaults. To return this
module to its factory default settings, you can either reset each parameter individually or do
a global recall following this procedure.
1
Rotate the hex switch to
0
.
1
Toggle the navigation switch to the bank number
0
.
2
Use the control LEDs to verify which bank you have selected, or use an available 6800
+
software control option (serial/local or Ethernet/remote) to aid in confirming your bank
selection.
3
Rotate the hex switch to the global recall parameter
F
.
4
Toggle the navigation switch to
On
.
Use an available 6800
+
software control option to aid in viewing, setting, and
confirming the parameter value.
Reading Software and Hardware Versions
The current software version of your module can viewed using a HTTP browser, a
CCS-enabled control panel, or a CCS software application, such as Pilot or Navigator. To
determine the hardware version number for SFS6803
+
and OP
+
SFS
+
modules, follow these
steps:
In CCS Navigator,
1
Discover the frame that contains the module, and save results of your discovery.
2
In the
Navigation
pane, right-click on the module and select
Configuration
.
3
In the
Configuration
dialog box, select the
Version
tab.
4
In the
Item Name
list, look at the
Hardware
menu item. If it is expandable and provides a
version number, then the revised specifications apply to your module. If the
Hardware
menu item is non-expandable and provides no version information, then the original
specifications apply.
In an internet browser,
1
Enter the IP address of the frame that contains the module.
2
In the
Navigation
pane, click on the module to expand its menu, and then select
Configuration
>
Version
.
If the
Hardware
item displays a version number, then the revised specifications apply to
your module. If the
Hardware
menu item provides no version information, then the
original specifications apply.
Changing Parameter Settings Using CCS Software
Before using CCS Navigator to change your module’s parameter settings, you must discover
the module. Discovery is the process by which CCS Navigator finds, and then connects to
your module.
Identifying Your Module in CCS Software
Whether your module is a SFS6803
+
or an OP
+
SFS
+
, when you discover it in CCS
Navigator, the module is identified as a SFS6803
+
.
Содержание Selenio 6800 SFS6803+OP+SFS+
