8
2.
Make sure that the power cord is unplugged.
Remove and discard the two screws (A) and the
shipping bracket (B) on the right side of the Base
(74).
Then, remove and discard the screws
and the shipping bracket (not shown) on the
left side of the Base.
Next, remove the tie securing the Upright Wire
(63).
Then, press a Base Cap (70) into the front of
each side of the Base (74).
2
B
A
74
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 7.
• Assembly requires the following tools:
the included hex key
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
ASSEMBLY
Tie
63
70
1. To make assembly easier, make sure that you have read and understand the information in the box above.
