GETTING STARTED
Location of Controls (Rear View of Main Unit)
29. AC
Plug the AC power cord into this socket before plugging it into the wall outlet.
Note
: When the system is connected to AC power, parts of the unit may be in operation due to
its stand-by feature. In order to turn the system completely off, remove the AC power
cord from the AC outlet.
30. FM ANT.
FM antenna “pigtail” wire
31.
SPEAKERS L
Terminals for the left channel speaker
32.
SUBWOOFER Output Jack
Connect an external subwoofer speaker (included)
33.
SPEAKERS R
Terminals for the right channel speaker
29
30
31
32
33
GETTING STARTED
You can achieve acceptable reception if you use the supplied FM pigtail antenna. If so, the antenna
should be elongated and not coiled or bunched up. If it hangs freely, it can be quite effective.
Antenna Connection
Insert LEFT speaker’s striped wire into LEFT channel’s speaker block (31) by pressing the RED lever
and inserting the striped wire into the open hole. Do the same with the LEFT speaker’s
non-striped wire and the BLACK lever. Repeat for the RIGHT channel SPEAKER block (33) and the
RIGHT speaker’s wire.
Speaker Connection
This unit includes a subwoofer output jack on the rear panel labeled “SUBWOOFER OUT”. You may
connect an external, powered subwoofer(included) using a single RCA-type cable as shown below.
Subwoofer Connection
Connect the power cable (included in the accessories) first to the power socket (29) at the unit and
then insert the power plug into the wall outlet. When you disconnect the plug from a socket, do
not pull the cable, always pull the plug.
Note
: As soon as the unit has been connected to AC power, parts of the unit are in operation, due
to the standby function. To switch off the unit completely, remove the plug from the AC outlet.
Once the unit is plugged in, its time display (3) starts flashing, refer to “
Setting the digital clock
”
on Page 18.
AC Power Connection
Cable (included)
Subwoofer
iLuv | 10
i9300 | V10M10_IM_EN_11112008
9 | iLuv
