Iluv i9300, Инструкция по эксплуатации

Страница: 10 / 21

OPERATIONAL INSTRUCTIONS
Amplifier and Radio Operation - continued
4. Press the
MEM./CLK ADJ.
button
again to store the station along
with its preset. Repeat as required.
Note
: You can also directly select the desired program preset by pressing numeric buttons 0~9 /
+10 (35) on the remote control. Store any remaining stations by repeating the process.
Changing a program position
If a memory position needs to be replaced by a station other than the current one, the new station
can be programmed as described above, and this will automatically replace the original station.
OPERATIONAL INSTRUCTIONS
Digital Clock and Timer
Setting the digital clock
When you first plug in the unit,
the display shows:
Note :
To set the clock to the current time,
proceed as follows:
1.
Press MEM./CLK ADJ. and the hour
will begin to flash.
2.
Enter the hour by pressing the
buttons SKIP/SEARCH
or TUNING - SKIP/SEARCH .
3. Confirm the hour entry by pressing
MEM./CLK ADJ. The minutes will then
begin to flash.
4.
Enter the minutes by pressing the buttons SKIP/SEARCH or TUNING
– SKIP/SEARCH and confirm with MEM./CLK ADJ.
To switch to the clock display while in tuner and CD modes, press DISPLAY MODE . The time is
displayed for approximately 5 seconds. The time is also displayed when the unit is turned off.
Setting the timer
You can set automatic switch-on and switch-off times with the built-in timer. Before you do this, be
sure the clock is set correctly.
1.
With the unit on, press DISPLAY MODE
(9)/(42), as required, until TIMER ON
appears in the display.
2.
Press MEM./CLK ADJ. (22)/(53) and
the hour will begin to flash. Use the
SKIP/SEARCH or
TUNING - SKIP/SEARCH to set
the hour of the desired switch-on time.
iLuv | 18 i9300 | V10M10_IM_EN_11112008 17 | iLuv
EU Only
EU Only
EU Only