Iluminarc Colorist POD 18Qa, Руководство пользователя

Страница: 6 / 23

Introduction
2 Colorist™ Pod 18Qa User Manual Rev. 2
There are no
user-serviceable
parts inside this
product. Any reference to
servicing you may find in
this User Manual will only
apply to properly certified
ILUMINARC® technicians.
Do not open the housing
or attempt any repairs
unless you are certified to
do so.
Please refer to all
applicable local
codes and
regulations for the proper
installation of this product.
Keep this manual
for future
consultation. If
you sell this
product to another user,
make sure that they also
receive this manual.
In the unlikely
event that your
Colorist™ Pod
18Qa may require service,
please contact
ILUMINARC® Technical
Support.
Please consult
with an Iluminarc
Sales
Representative on the
suitableness of this
product for your
installation. Failure to
follow these guidelines or
the recommendations of
the Iluminarc Sales
Representative may result
in the product warranty
being rendered VOID and
any repair cost being the
sole responsibility of the
buyer.
Safety Notes
Please read all the following Safety Notes carefully because they include important
information on how to install, use, and maintain this product safely.
Personal Safety
•
Avoid direct eye exposure to the light source while the product is on.
•
Always disconnect this product from its power source before servicing.
•
Always connect this product to a grounded circuit to avoid the risk of electrocution.
•
Do not touch this product’s housing when operating because it may be very hot.
Mounting and Installation
•
This product is for outdoor use (IP65). All indoor and limited outdoor permanent
installations.
•
Not for permanent outdoor installation in locations with extreme environmental
conditions. This includes, but is not limited to:
o
Exposure to a marine/saline environment (within 3 miles of a saltwater body
of water).
o
Where the normal high or low temperatures of the location exceed the
temperature ranges in this manual.
o
When mounting outdoors, do not point the product straight down.
o
Locations that are prone to flooding or being buried in snow.
o Other areas where the product will be subject to extreme radiation or caustic
substances.
•
CAUTION: When transferring product from extreme temperature environments, (e.g.
cold truck to warm humid ballroom) condensation may form on the internal electronics
of the product. To avoid causing a failure, allow product to fully acclimate to the
surrounding environment before connecting it to power.
•
Make sure there are no flammable materials close to this product while it is operating.
•
When hanging this product, always secure it to a fastening device using a safety cable
(not provided).
Power and Wiring
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
•
Always make sure that you are connecting this product to the proper voltage, as per the
specifications in this manual or on the product’s sticker.
•
Never connect this product to a dimmer pack.
•
Make sure that the power input cable is not cracked, crimped, or damaged.
•
Never disconnect this product by pulling on the power input cable.
Operation
•
The maximum ambient temperature range is -20 °F to 110 °F (-29 °C to 43 °C). Do not
operate this product outside these temperatures.
•
In case of a serious operating problem, stop using this product immediately!