© 6/2016 Ilmor Marine Engines, Version 1.0
4-9
MAINTENANCE
Lubricating the Unit Bearing (Gimbal Housing)
Apply approximately 8 to 10 pumps of grease to the unit bearing (gimbal
housing) grease fitting (
Figure 4-5, 1
) to lubricate the unit bearing (gimbal
housing). Use a typical hand-operated grease gun to apply the grease.
1
Figure 4-5
Description
Where used
Urea grease water resistant type, NLGI #2
Unit bearing
(gimbal housing)
Lubricating the Engine Coupler
See Lubricating the Engine Coupler on page 4-6.
Checking the Circuit for Loose or Damaged Connections
Check the electrical connections and leads for damage and corrosion.
Testing the I-CaPS Unit Output
See Ilmor Cathodic Protection System on page 2-11.
Checking the Steering System for Loose, Missing or Damaged Parts
Check the steering system and tighten any loose parts, replace any missing
or damaged parts.
Checking the Remote Control for Loose, Missing or Damaged Parts
See Remote Controls on page 2-9.
Lubricating the Shift Cable and the Linkages
A
CAUTION!
Never grease the steering cable while extended.
Hydraulic lock could occur and cause loss of steering control.
