SECTION 3
ILMOR ONE-DRIVE OWNER’S MANUAL
3-3
© 6/2016 Ilmor Marine Engines, Version 1.0
5. Slide the aft thrust hub onto the propeller shaft, with the tapered side
toward the propeller hub (toward end of shaft).
6. Align the splines and place the propeller on the propeller shaft.
7. Install and torque the rear propeller nut. Check the propeller at least
every 20 hours.
Rear propeller nut torque
N·m
lb-ft
80
59
8. Install the propeller shaft anode bolt with a washer. Torque the bolt.
Propeller shaft anode bolt torque
N·m
lb-ft
30
22
REMOVING THE PROPELLER
WARNING!
The remote control must be in NEUTRAL and the starter
key removed from the switch before removing and/or installing the
propeller.
1. Place a wood block between the propeller blades and the
antiventilation plate to prevent rotation.
WARNING!
Place a block of wood between the antiventilation plate
and the propeller to protect hands from propeller blades and to
prevent the propeller from rotating when removing the propeller
nut.
2. Turn the rear propeller nut (36 mm [1-7/16 in.]) counterclockwise to
remove the nut.
3. Slide the propeller and the thrust hub off the propeller shaft.
4. Turn the front propeller nut (70 mm [2-3/4 in.]) counterclockwise to
remove the nut.
5. Slide the propeller and the thrust hub off the propeller shaft.
