Ilford ILFOLAB 1250 RC, Руководство по эксплуатации

Страница: 20 / 26

7
FAULT FINDING
18
Sheet fed upside down Feed sheets emulsion side up
Prints pulled from the exit Leave prints to emerge fully
rollers from the dryer before handling
them
Dirty paper guides Remove roller assemblies and
inspect guides. See figure 3.1.
Clean guides as necessary
Dirty feed tray Clean feed tray. See figure 3.1
Paper guides bent Contact your local ILFORD
Selling Company
Dryer speed too high Adjust speed control to a slower
setting
Faulty heater element Contact your local ILFORD
Selling Company
Rollers operating incorrectly Replace any damaged or
missing roller tension springs.
See section 6.4. Clean rollers.
See section 6.2. Ensure the
yellow transit wedges have
been removed. See section 3.4
Symptom Possible cause Remedy
Scratches on prints
Wet or damp prints
1
2
This section provides a list of checks to make should there be any
problems with the dryer. If the problem persists, contact your
nearest ILFORD Selling Company at the address shown on the
back cover of this manual.
CAUTION
If in doubt about making any of the checks consult a competent
engineer. Any further repair work carried out by unqualified
personnel could cause a hazard both to yourself and to the
equipment, and may invalidate any guarantees applicable to the
equipment.
Note
An interlock switches off the fan motor, drive motor and heaters if
the dryer lid is raised.