Ilford ILFOLAB 1250 RC, Руководство по эксплуатации

Страница: 15 / 26

6
CLEANING AND SIMPLE
REPAIRS
6.1
1
2
6.2
1
2
3
4
5
13
See figure 6.1.
Cleaning is the only regular maintenance required on the
ILFOLAB 1250RC dryer. Regular cleaning will ensure correct
operation and consistently high drying quality.
CAUTION
During the following procedures, do not allow water to enter
areas of the dryer containing electrical components. Please refer
to the Safety Precautions at the front of this manual.
DAILY ROUTINE
Change the water in the wet-print dish daily or more frequently if
necessary.
Wipe the outside of the dryer with a damp cloth.
CLEANING THE FRONT ROLLER ASSEMBLY
See figure 3.1.
CAUTION
When cleaning the roller assembly, always take extreme care
not to damage the roller surfaces. Damaged roller surfaces will
cause marks on subsequent prints.
If the four-roller assembly at the front of the dryer becomes
contaminated, remove and clean it as follows:
Switch the electrical supply off.
Press the release button and open the dryer until the lid is held
securely by the restraining arm.
Lift the four-roller assembly away.
Thoroughly clean the rack with a soft lint free cloth and warm
water. More stubborn deposits on metal and plastic surfaces can
be removed using a soft bristle brush and warm water.
CAUTION
To prevent a reduction in the quality of drying, particularly on
glossy surfaces, do not use soap solutions or other cleaning
agents on the rollers.
Refit the four-roller assembly and close the dryer.
Figure 6.1
Upper roller, rear
Lower roller, rear
Lower cover
Restraining arm
Front roller assembly
Print exit guide
Ventilation grille
Alignment mark
Washer
Nut
1
2
3
4
5
6
7
8
9
10