IKH xw032, Инструкция по эксплуатации

Страница: 23 / 26

23
Problem Cause Solution
Motor run-
ning too hot 1. Blade tension too high
2. Drive belt tension too high
3. Gears need lubrication
4. Cut is binding blade
5. Gears aligned improperly
1. Reduce tension on blade
2. Reduce tension on drive belt
3. Check oil bath
4. Decrease feed and speed
5. Adjust gears so that worm is in center of
gear
Bad cuts
(crooked) 1. Feed pressure too great
2. Guide bearings not adjusted
properly
3. Inadequate blade tension
4. Dull blade
5. Speed incorrect
6. Blade guides spaced out too
much
7. Blade guide assembly loose
8. Blade track too far away from
wheel flanges
1. Reduce pressure by increasing spring ten-
sion on side of the saw
2. Adjust guide bearing, the clearance cannot
be greater than 0,001”
3. Increase blade tension
4. Replace blade
5. Adjust speed
6. Adjust guide space
7. Tighten
8. Retrack blade according to instructions
Bad cuts
(rough) 1. Too much speed or feed
2. Blade too coarse
3. Too loose blade tension
1. Decrease speed or feed
2. Replace with finer blade
3. Adjust blade tension
Blade is
twisting 1. Cut is binding blade
2. Too much blade tension
1. Decrease feed pressure
2. Decrease blade tension