IKH xw032, Инструкция по эксплуатации

Страница: 20 / 26

20
CHANGING SPEED
Always change the blade speed to best suit the material being cut (see material cutting chart below).
1. Turn off the machine and unplug it. Open the pulley guard cover. Loosen the leadscrew (98) and
you are able to change the position of the belt to gain the desired speed. Check the belt tension.
After the belt tension is well adjusted, lock the motor firmly and close the pulley guard cover.
Material cutting chart
Material
Speed (m/min) Belt groove used
50 Hz Motor pulley Saw pulley
Tool, stainless or alloy steel, bearing
bronzes
Mild steel, hard brass or bronze
Soft brass, aluminium, other light
materials 20 m/min
29 m/min
50 m/min
Small A
Medium B
Large C
Large D
Medium E
Small F
BLADE SELECTION
1.
A general use blade (12,5 x 0,64 x 1638 mm, 14 teeth per inch) is delivered with the machine.
2. The choice of blade pitch is governed by the thickness of the work to be cut; the thinner the
workpiece, the more teeth are advised. A minimum of 3 teeth should be in the workpiece at all
times for proper cutting.
3. If the teeth of the blade are so far apart that they straddle the work, severe damage to the work-
piece and to the blade can result.
CHANGING BLADE
Raise the saw head to vertical position and open the blade guard. Loosen the blade tension adjusting
knob sufficiently to allow the saw blade to slip off the wheels. Install the new blade as follows:
1. Place the blade in between guide bearings.
2. Slip the blade around the motor pulley (bottom) with your left hand and hold in position.
3. Hold the blade taut against the motor pulley by pulling the blade upward with your right hand
which is placed at the top of the blade.
4. Remove your left hand from the bottom pulley and place it at the top side of the blade to con-
tinue the application on the upward pull on the blade.
5. Remove your right hand from the blade and adjust the position of the top pulley to permit your
left hand to slip the blade around the pulley using the thumb, index finger and little finger as
guides.
6. Adjust the blade tension knob clockwise until it is just right enough so no blade slippage occurs.
Do not tighten excessively.
A D
B E
C F
Motor pulley Saw pulley