IKH XW029, Инструкция по эксплуатации, Страница: 37 / 58

37
side of stand, then use 8 M8x12 hexagon head bolts with 16
∅
8 washers and 8 M8 nuts to tighten
the stand and level feet.
Installing the extension table
WARNING: For installing the extension table you will need another person’s help.
1. Take the extension table from the carton and put
8 M8x20 hex head screws with 8 mm washers in
holes so the screw heads extend outward 10 mm.
2. Lift the extension table slightly and screw four
screws up on the holes of the major table.
3. Center the extension table over the edges and tap
it. Check the surface alignment.
4. Tighten the 8 screws with a 12 mm wrench.
Note: The left and right extension tables can be
exchanged.
Installing the front rail
WARNING: The front and rear rails must be carefully aligned to reduce the risk of kickback,
which can cause serious injury.
Take out the front rail from the carton. For installing the front rail you need the following hardware:
-
5 M8x25 square head bolts
- 5 8mm flat washers
- 5 M8 hex nuts
- right and left end caps for front rail
- 6 ST3,9x12 tapping screws
1. Insert the 5 square head bolts into the table and extension so the bolt heads extend out 6 mm.
2. Loosely attach a flat washer and a hex nut to each bolt.
3. Slide the slot on the front rail over the bolts. Adjust each bolt to fit the rail closely to the table.
4. Push the front rail against the table and hand-tighten each hex nut. Note: Make sure there are no
gaps between the rail and edge of table or extensions.
5. Put the end caps on the rail ends. Insert the tapping screw and tighten with Phillips-screwdriver.
Block of wood
Major part, table
Extension table
Viewed from the front side
Tap here
Major part, table
Extension table
Extension table
Major part, table
Tap here
Viewed from the top