Ikeno Dehumidifier ID-3750, Руководство пользователя

Страница: 4 / 12

- 3 -
IKENO INDUSTRIAL DEHUMIDIFIER - USER'S MANUAL - Model ID-series
Subject to change without prior notice
•
The unit can be installed conveniently. The conventional type and the wall hanging type
can be installed on anyplace in the room and can be used after being powered. The
unit installed outside must be covered under shield to avoid sunlight and rain.
•
The wall hanging type is suitable for the narrow place needing be dehumidified for its
small cubic.
•
The high temperature type can be used to dehumidify the room where the primary
materials of drying, food, chemical, marine product, farming product, printed matter,
crude drug, etc..
2. COMPONENT IDENTIFICATION
3. WORKING PRINCIPLE
Main working components are:
high efficient compressor,
accumulator, magnetic flow control
valve, evaporator coil, condenser
coil, capillary tube, centrifugal fan,
temperature sensor, humidity sensor
and electrical wiring.
The centrifugal fan makes wet air
entering into the evaporator through
air filter,then the air is cooled down.
When the surface temperature of
the evaporator is lower than the
dew-point temperature of the air,
the water content in the air is
condensed and drained from the
machine.
The dehumidified air is then heated by the condenser and is discharged into the room by
the centrifugal fan. Thus, the air goes through the cycle and the water in the air gets
condensed so as to achieve dehumidification.
When the environment temperature is lower ( 5
o
C - 18
o
C ) during running, the surface of
the evaporator will be frosted due to lower temperature. The computer will judge and
1. Return air inlet
2. Drainage outlet
3. Humidistat
4. Control panel
5. Dry air outlet
6. Partial condenser
6