9
STEP 3 - Opening the Housing
Lid Snaps have a
Lock
.
1. Push Lid Snap Locks forward and lift as shown. Open opposing Lid
Snaps simultaneously. Keep pressure on the Lid Snaps so they do not
fly open quickly.
Some Lid Snaps have a lot of spring tension once they go over center,
so keep a firm grip on each Lid Snap. Lid Snaps may also be opened
one at a time.
2.
Remove the Housing Back.
Note:
If the back is hard to
remove, place the Open Lid
Snap End under the lid hook
and against the housing. Lift
up on the Lid Snap Tab to
break the housing seal.
Push Forward
Lid
Snap
Lock
Lift
1. Make sure the camera battery is fully charged and a SD card is inserted
into the camera.
2. Rotate Housing Lens Release Button control up and forward against
front of housing.
3. The Mounting Plate is secured to the inside bottom of the housing. The
camera Mounting Tray slides into the Mounting Plate. Use the index
finger of your hand to pull the Tray Removal Screw on the back of the
Mounting Tray away from the Mounting Plate,
Diagram A, page 10
. Use
your thumb to apply opposite pressure against the bottom of the housing
to assist in removal of the Mounting Tray.
STEP 4 - Installing Camera in the Housing
Open Lid Snap End
Lid Snap Tab
