12
STEP 6 - Closing the Housing
1. Place housing face down in your lap or on a flat surface. Check to see
that there is an o-ring on the housing back, and that it is clean and in its
proper location.
2. Guide the back onto the housing front. Make sure the hotshoe wire is
out of the way. Once the back is properly installed, the o-ring should
touch the housing all the way around. There should be an even gap on
each side of the
housing between
the housing and
the back.
3. Lift the lid snaps so
they are extended
and place each lid
snap into the
corresponding
hook on the
housing back.
4. To close the
housing, push
down on the
opposing lid snaps simultaneously until they snap into place. Be sure
they are down far enough to engage the
lock
-
Page 9
. The o-ring seal
should now appear as a solid black line from the back of the housing.
Housing Back
O-ring
Even gap on
all four sides
Lid Hook
Lid
Snap
STEP 5 - Attach the Hotshoe
Slide Hotshoe into the top camera mount until it stops,
Diagram D,
page 11
. Hotshoe must be all the way forward in the camera mount to
assure a good electrical connection with a strobe.
Make sure Hotshoe cord does not interfere with controls or the housing
back when closing the housing.
