Usage
Final Check
The clear housing permits instant visual inspection of the camera and
sealing surfaces as well as complete monitoring of controls and camera
LCD screens. This housing has been factory water pressure tested to
200 ft (60 m).
Once the housing is closed, check the o-ring seal. Check the gap
between the housing back and the housing. It should be even all the
way around the housing.
Look through the clear plastic back at the o-ring. You should see a
darkened area where the o-ring is compressed against the housing
back. If you do not see an even black compression seal all the way
around the back, open the lid snaps, reseat the housing back and close
the lid snaps. Visually check the seal again.
Zoom Control
(lever type only)
After you have used the housing's zoom
control, it must be returned to the center
position to disengage. If the housing zoom
control is pushing the zoom lever in either
direction, you may not be able to take a
picture or access other functions. This is
because the camera is receiving a signal
from the engaged zoom control.
+
-
+
-
Zoom
Control
“Engaged”
Zoom Control
“Disengaged”
(Center Position)
9
Deflector Purpose
The Deflector should be installed when using any external strobe. The
Deflector will block and redirect the camera’s flash to an optional AF35
slave unit or fiber optic cord, which sends the firing signal to the strobe.
The Deflector also stops the built-in flash from creating backscatter in
the image. Remove the Diffuser when using the Deflector.
