Ikegami HDL-45E, Руководство по эксплуатации

Страница: 23 / 84

4. INSTALLATION and CONNECTIONS 4 - 3
1. Insert the camera into the tripod mount plate (T-230), when the tripod screw hole aligns with the tripod mounting screw of
the V Wedge adaptor.
2. Tighten the tripod mounting screw of the V Wedge adaptor, and then secure the V Wedge adaptor by closing the lock lever
on the tripod mount plate (T-230).
3. Set the T-230 tripod mount plate with camera body on the tripod. Make sure that the camera is fastened to the tripod mount
plate and not loose.
4.3 Lens Mounting
This section explains how to mount the lens on.
Red mark (position mark)
LENS
Bayonet ring knob
Lens connector
Camera front view
Camera front view
Position mark
LENS
Pigtail cord
1. Remove the protective cap from the camera side mount by rotating the bayonet ring knob clockwise. Also remove
the protective cap from the lens side cap.
2. Align the position mark on the lens side mount groove with the position mark on the camera side mount.
3. Secure the lens by rotating the camera side mount bayonet ring knob clockwise.
Ensure that the lens is properly secured and not loose.
4. Locate the pigtail cord which is located on the lens side push this cord in to the lens connector of camera.
Be sure to push the pigtail cord until it clicks in to position.
CAUTION
Do not hold its lens because the mount may be unduly stressed
and could bend or break. If the camera is supported grasping its
lens, HDL-45E/E1 may easily fall and cause injury.