15
Verify Anti-Tip Bracket Is Installed and
Engaged
On Ranges Equipped with a Storage Drawer:
1.
Slide range into final location, making sure rear leveling leg
slides into anti-tip bracket.
2.
Remove the storage drawer. See the “Remove/Replace
Drawer” section.
3.
Use a flashlight to look underneath the bottom of the range.
4.
Visually check that the rear range foot is inserted into the slot
of the anti-tip bracket.
Remove/Replace Drawer
Remove all items from inside the baking drawer, warming drawer
or premium storage drawer, and then allow the range to cool
completely before attempting to remove the drawer.
To Remove:
1.
Open the drawer to its fully open position.
2.
Raise the front edge, and then lift out.
To Replace:
1.
Align the forward drawer notches with the notches in the
drawer rails on both sides. Place the rear alignment tabs
into the drawer rails on both sides.
2.
Push the drawer in all the way.
3.
Gently open and close the drawer to ensure it is seated
properly on the rails on both sides.
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1.
Open oven door all the way.
2.
Pinch the hinge latch between two fingers and pull forward.
Repeat on other side of oven door.
3.
Close the oven door as far as it will shut.
4.
Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven doorframe.
To Replace:
1.
Insert both hanger arms into the door. Be sure that the hinge
notches are engaged in the oven doorframe.
2.
Open the oven door.
The door should be able to open all the way.
3.
Move the hinge levers back to the locked position. Check that
the door is free to open and close and is level while closed. If
it is not, repeat the removal and installation procedures.
A
A. Hinge latch
A
A. Hinge notch
