IKEA LAGAN 605.220.92, Руководство пользователя

Страница: 12 / 24

To ignite the burner:
1. Push the control knob and turn it
anticlockwise to the maximum position
marked with
.
2. Keep the control knob pushed for about
5 sec. As a result thermocouple heats up,
and the safety device switches off. If you
do not push the knob, the gas supply is
interrupted.
3. When you light the flame, you can adjust
it.
If the burner does not ignite, after
a few attempts, check if the crown
and its cap are in correct
positions.
1
2
3
4
5
1
Burner cap
2 Burner crown
3 Ignition candle
4
Injector
5 Thermocouple
Warning! Do not keep the control
knob pressed for more than 15
seconds. If the burner does not
light after 15 seconds, release the
control knob, turn it into off
position and wait for at least 1
minute before trying to light the
burner again.
If there is no electricity, you can
ignite the burner without an
electrical device. In this case,
approach the burner with flame,
push the relevant knob and turn it
anticlockwise to the maximum
gas release position.
Warning! Be careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in case
of misusing the flame.
If the burner accidentally goes
out, turn the control knob to the
off position and wait for at least 1
minute before trying to light it
again.
When you switch on the mains
after installation or a power cut,
the spark generator activates
automatically.
The hob is supplied with the
progressive valves. They make the
flame regulation more precise.
Turning the burner off
To put the flame out, turn the relevant
control knob clockwise to the symbol .
Warning! Always turn the flame
down or switch it off before you
remove the pans from the burner.
Hints and tips
Warning! Refer to Safety
chapters.
ENGLISH 12