7
Safety and important notice
WARNING:
• Risk of overheating! Never install the
product in a confined space. Always
leave a space of at least 5 mm around
the product for ventilation. Ensure
curtains or other objects never cover
the ventilation slots on the product.
• Never place the product or batteries
near open flames or other heat
sources, including direct sunlight.
• Only use this product indoors. The
apparatus shall not be exposed to
dripping or splashing, no objects filled
with liquids, such as vases, shall be
placed on the apparatus.
• Never place this product on other
electrical equipment.
• The mains plug or an appliance
coupler is to be used as a disconnect
device, the disconnect device shall
remain readily operable.
• If the supply cord is damaged, replace
it with a new cord set which is type-
approved for your country.
• Batteries (battery pack or batteries
installed) shall not be exposed to
excessive heat such as sunshine, fire
or similar.
IMPORTANT!
• The speaker is for indoor use only and
can be used in temperatures ranging
from 0º C to 40º C.
• Do not leave the speaker in direct
sunlight or near any heat source, as it
may overheat.
• Do not subject the speaker to
wet, moist or excessively dusty
environments, as this may cause
damage.
• The range between the speaker and
the receiver is measured in open air.
• Different building materials and
placement of the units can affect the
wireless connectivity range.
• Too high volume can damage your
hearing.
• Do not touch the acoustic
components.
• Don not use the product as a shelf or
stand.
Other Settings
Unpair Bluetooth devices
Press and hold the knob (1). Release the knob when the LED
light turns red the first time.
A confirmation sound will be played.
(Note that on some phone models you also need to remove
ENEBY20/30 from the phone’s paired devices list to be able to
pair again.)
Set up a stereo pair
You can pair two identical ENEBY speakers to create a wider
stereo experience. In this configuration, one speaker serves
as the left channel and the other serves as the right channel.
On/Off and Volume need to be controlled individually on each
speaker.
1. Turn on both speakers.
2. Press and hold the knobs (1) at the same time. Release the
knobs when the LED light turns red the second time.
Wait 2 seconds. A confirmation sound will be played.
3. Press the knob (1) once again on one of the speakers.This
speaker is now assigned as the left channel.
4. Open the Bluetooth setting on your mobile device and
connect to ENEBY speaker for the left channel.
To disable the stereo pair, follow instructions “Unpair
Bluetooth devices” on both speakers.
Set bass and treble
Press and hold the knob (1). Release the knob when the LED
light turns red the third time.
This activates the bass setting. The LED light flashes slowly.
Turn left/right to adjust the bass. Confirm the bass setting
and activate the treble setting by pressing the knob once. The
LED light flashes quickly. Turn left/right to adjust the treble.
Confirm by pressing the knob once and this also exits the
sound settings.
Disable the auto-off
function
Press and hold the knob (1). Release the knob when the LED
light turns red the fourth time.
A confirmation sound will be played. ENEBY will now not turn
off automatically.
Factory reset
Press and hold the knob (1). Release the knob when the LED
light turns red the fifth time (after approximately 30 seconds).
A louder confirmation sound will be played. The factory reset
will clear all Bluetooth devices and sound settings, and it will
activate the auto-off function.