11
Activate the setting function of maximum temperature of the dispersing medium by pressing
"Max. Temperature" button (H).
"Max. Temperature" setting indicator (G) lights up.
Change the setting by rotating the "Start/Stop" knob (K).
Start the device by pressing the "Start/Stop" knob (K).
Note:
When the dispersing medium reaches the set temperature, the device stops and a warning
message is shown on display (A) and (B): hot tool (see section "Warning message").
While running, the "Max. Temperature" setting can be checked by pressing the "Max. Tempera-
ture" button (H)
.
Activate the setting function on the tool maintenance time of
S 25 EC-T...
dispersion tool
by pressing
S 25 EC-T...
dispersion tool button (J) 3 seconds.
Display (B) switches to tool maintenance time.
The
S 25 EC-T...
dispersion tool indicator (I) flashes.
Press the "Start/Stop" knob (K) to reset the tool maintenance time.
Setting the "Max. Temperature":
Checking the tool maintenance time:
Resetting the tool maintenance time:
The default maintenance time of
S 25 EC-T...
dispersion tool is 20* hours. We recommend to check and carry out necessary
maintenance (e.g. replacing the bearing) to the dispersion tool when the service time elapse.
When the tool maintenance time reach 0, the device will not stop, but we recommend a maintenance of the tool as soon
as possible. After the maintenance in a
IKA
service workshop the maintenance time will be reset from the service team. In
all other cases it is possible to reset the maintenance time with the device. Description see below.
To
check the tool maintenance time of
S 25 EC-T...
by pressing
S 25 EC-T...
dispersion
tool button (J).
Display (B) shows the tool maintenance time about 2 seconds.
The "min: sec" indicator (N) or "h:min" indicator (C) show the unit of the time value.
S 25 EC-T...
dispersion tool indicator (I) flashes twice.
Display (B) switches to show the timer value.
Note:
The tool maintenance time can be checked in either stop or running status.
When the tool maintenance time is less than 30 minutes, the
S 25 EC-T...
dispersion tool indi-
cator (I) changes from green to red color.
When the tool maintenance time reaches 0, the value (00:00:00) flashes and meanwhile the
indicator LED (I) is red and flashes.
*
Note:
The maintenance time of
S 25 EC-T…
dispersion tool can be set between 4 to 40 hours according to the request
of your application by rotating the "Start/Stop" knob immediately after resetting the tool maintenance time. The new
value has to confirm by pressing the "Start/Stop" knob. This new value will be the resetting value when the tool will reset
the next time.
For T25 easy clean control with S 25 EC-T... dispersion tool only:
