32
Lift position key (4&6) (Fig. 23a and Fig. 23b)
To adjust the lift position, grasp the handle and press the left or
right lock button (
4
).
The hand must rest on the sensor (
6
).
Note: Hand detection sensor
(6)
, only to be touched by hand,
do not press!
The lift lock is unlocked and you can move the lift up and down.
Release the lock button or remove the hand from the lift, the lift
is locked in the adjusted position.
When locking and unlocking, a clear “click“ sound is heard.
4
6
Fig.23a
Fig.23b
Assembling the stand pillar RV 8.1 (Accessories)
No stand is required if the condenser has been properly fitted
and secured by tightening the condenser union nut on the rotary
drive.
The purpose of the stand is solely to prevent the condenser
twisting.
Caution:
If the RV 8.1 stand is fitted incorrectly, the strong forces
at the Velcro strap can cause stresses within the glass, which in
turn can cause damage to the glass condenser.
After the condenser has been fitted, the RV 8.1 stand is attached
to the rotary drive. Make sure that the condenser is installed
parallel to the lift body.
- Guide the stand rod through the hole on the underside of the
rotary drive,
- Screw the knurled screw into the tapped hole but do not tighten
it,
- Move the stand until the upper rubber sleeve rests against the
glass condenser,
- Tighten the knurled screw finger-tight,
- Secure the condenser to the stand using the pre-fitted Velcro
strap.
Fig.24
Rotary drive
WARNING
Stand pillar RV 8.1
Condenser
Содержание RV 8
Страница 1: ...20000006119 RV 8_072017 IKA RV 8 ...
