26
a.) Turn off the device with the power
switch.
b.) Hold down the right turn button
and turn on the device with the
power switch. Let go of the turn
button after about 5 seconds.
c.) You can activate
(SOUND ON
) or
deactivate
(SOUND OFF)
the
audio signal indicating that time
has expired by pressing the right
turn button.
Note:
If the time expiration signal has been activated, expiration of the
set time is indicated by a sequence of signals (3 times 5 short tons at
intervals of about 10 seconds).
Adjusting the lock function
The lock function of the agitation table can be activated or deactivated
with a direct connection to the setting of the audio time expiration
signal.
The following steps are required to activate or deactivate the function:
a.)
Turn off the device with the
power switch.
b.)
Hold down the right turn
button and turn on the devi-
ce with the power switch.
Let go of the turn button
after about 5 seconds. After
you have run through the
Sound
On/Off
routine, it is
possible to activate or deac-
tivate the lock function.
c.)
You can activate (Lock
On
) or
deactivate (Lock
Off
) the lock function by pressing the righ
turn button.
The activated lock function is displayed by the = icon in the right dis-
play. If you cannot see the = icon in the right display, the lock function
of the agitation table is turned off.
ATTENTION!
After a power failure, the unlocked (freely
movable) agitation table will continue to perform a circular
motion until the lock function can fasten the agitation table
in place.
Basic model
The amount of time required for the agitation process can be set with
the aid of the right turn button. A distinction is made for the agitation
time setting between timed mode and continuous operation. If conti-
nuous mode is selected (On LED is lit), the agitator can continue its agi-
tation function for any amount of time with the previously set speed.
If timed mode is selected, the agitation process can last for a maximum
of 50 m. The set time is displayed by the LED line. The flashing LED
shows the amount of time currently remaining After all LED’s have
gone out in timed mode, the device switches off into the Off operating
mode and the agitation process comes to an end.
Note:
The curently set time can be modified at any time. If the time
setting is set to the right beyond 50 minutes, the LED bar goes out and
the LED in the On operating state (continuous mode) starts to light up.
If you continue to hold down the turn button, the device first jumps to
the Off operating mode (standstill) and then back into timed operation.
The same applies in the opposite order if the turn button is held down
beyond a certain amount of time and moved to the left.
After the power failed, the set time (timed mode or continuous
mode) is erased and the device switches into Offline operating mode
(standstill).
Setting the agitation time
SV
SV
SV
Содержание KS 130 basic
Страница 51: ...51...
