Superiorfireplaces.US.com
127011-01B
16
AIR DEFLECTOR AND GLASS DOOR INSTALLATION
AIR DEFLECTOR AND GLASS DOOR INSTALLATION
Continued
INSTALLING AIR DEFLECTORS (42" MODELS ONLY)
Slide air deflector in between the front side face and side brick panel
(see Figure 30). The notched end of the deflector sits on bottom
hearth. Air deflector does not require any fastening.
The front side faces and side brick panels will hold the deflector in
place (see Figure 30).
DOOR FRAME MODELS
BDMO42E/G/C AND BDMO50E/G/C
Installation
1. Remove screws from smoke shelf (see Figure 29).
2. Mount top door frame and secure with screws provided (see
Figure 29).
3. Place bottom door frame on top of ash lip at front of fireplace
(see Figure 30).
4. Secure bottom door frame to brick with two hex screws provided
as shown in Figure 30 using a 7/16" open end or adjustable
wrench.
Figure 29 - Installing Top Door Frame
Top Door
Frame
Smoke
Shelf
WARNING: Discontinue use of the appliance im-
mediately if doors are damaged and contact a quali-
fied installer for repair. Only doors certified with the
appliance shall be used.
WARNING: Do not slam or strike doors. Damage
can result in a hazardous condition.
INSTALLING GLASS DOORS
Spring clips have been installed but some adjustments may be
needed. Install the doors using the following steps:
1. With bifold doors completely folded, insert bottom pivot pin into
pivot hole located near bottom corner of front face opening and
swing door to vertical position making sure top pins slide into door
track. Door is installed when top door pin snaps into spring clip.
2. Repeat step 1 for remaining door.
If you find the doors do not close properly or do not appear level or
straight, proceed with section on door adjustment,
Figure 30 - Installing Bottom Door Frame and Air Deflector
Hex
Screw
Bottom
Door
Frame
Ash Lip
Ash Lip
Air
Deflector
Figure 28 - Installing PureFire Hood
PUREFIRE HOOD INSTALLATION
1. The PureFire hood supplied with this fireplace is packaged in a
separate box and placed in the firebox during shipping.
2.
Remove hood from box. Locate brackets (quantity 2) and screws
(quantity 4) for hood installation in the hardware bag.
3.
Using screws provided, secure the bracket to the inner dome of
the fireplace as shown in Figure 28. The left and right bracket are
different. The edge that is straight will be closer to the fireplace
opening.
4.
Lift hood up into the fireplace and place it on the retaining
brackets (Figure 28). The rear of the hood will touching the rear
of the fireplace.