IHP F3772 Скачать руководство пользователя страница 3

3

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Figure 8 - Block-Off Plate

Figure 9

Figure 10 - Lights Baffle

Use the following instructions when installing the provided Block-Off 

Plate on Rear-Venting Fireplaces that do not have any vertical rise 

or elbows installed only.

INSTALLATION INSTRUCTIONS FOR BLOCK-OFF PANEL
1.  Locate the supplied Baffle Block-Off Plate (see Figure 8).
2.  Locate attachment holes for Block-Off Plate installation in new baffle 

as shown in Figure 9.

3.  Install the bent Baffle Block-Off Plate as shown in Figure 8 using 

the (2) screws provided in kit.

*

Figure 11 - Vent restrictor installation, Top vent

Figure 12 - Vent restrictor installation, Rear vent

Installation in top vent. Put flap (and wing if installed) 

directed toward the rear of unit.

Installation in rear vent. Install so flap (and wing if installed) 

will stay closed

To Termination

Flap Must Move 

Up Freely

Exhaust From Inside Fireplace

To Termination

Flap Must 

Move Up 

Freely

Exhaust 

From 

Inside 

Fireplace

Use screws to attach 

the new lights baffle

Screw baffle block off here

f i r e - p a r t s . c o m

Содержание F3772

Страница 1: ...HWH 10 16X1 2 Typ AB Blk 4 ea Screw 10 16x 38 HWH B Blk 1 ea Pilot Hood 1 ea Rear Baffle Block off Plate 40 models only 1 ea Baffle 40 DVA w Lights 1 ea Baffle 45 DVA w Lights 1 ea Installation Instructions TOOLS REQUIRED 5 16 Socket Screw Pliers 4mm Allen Wrench Small Flat Screwdriver FIELD SERVICE UPGRADES SHALL ONLY BE COMPLETED BY A QUALIFIED SERVICE TECHNICIAN CAUTION SHARP EDGES WATCH YOUR F...

Страница 2: ...placement per the manual when installing these units Verify pilot flame is not obstructed Reference manual to test fire unit and verify proper operation IF THE UNIT IS REAR VENTING CONTINUE ON TO INSTRUCTIONS ON NEXT PAGE 5 Remove the lintel from the old baffle by bending tabs up see Figure 4 and sliding the Lintel off of the front edge of the baffle 6 Remove light glass holders from old baffle by...

Страница 3: ...ion in new baffle as shown in Figure 9 3 Install the bent Baffle Block Off Plate as shown in Figure 8 using the 2 screws provided in kit Figure 11 Vent restrictor installation Top vent Figure 12 Vent restrictor installation Rear vent Installation in top vent Put flap and wing if installed directed toward the rear of unit Installation in rear vent Install so flap and wing if installed will stay clo...

Страница 4: ...is complete with the installation of the Block Off Plate 4a Remove pilot head by pulling up firmly discard it and verify proper pilot gas setting For Natural gas units the orifice should be turned counter clockwise For Propane LP gas units the orifice should turned clockwise Some pilot orifices require a small flat standard screwdriver and somerequirea4mmallentypewrenchtorotatetheorifice in the pi...

Отзывы: