ihp.us.com
901176-00 NC
11
OPERATION
ELECTRONIC LIGHTING INSTRUCTIONS
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device that automatically lights the pilot. DO NOT attempt
to light the pilot by hand.
B. BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s
instructions. If you cannot reach your gas supplier, call the fire department.
C. Use only the remote to light the pilot. This valve will not operate if the pilot is not lit and stable.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been
under water. Attempted operation may result in fire or explosion resulting in property damage, personal injury
or loss of life.
REMOTE LIGHTING
CAUTION:
DO NOT attempt to light the pilot by hand.
Note:
If the remote does not function, and batteries with an adequate power
level are installed, refer to the TRANSMITTER FUNCTION section.
Note:
Step 1 may not be required if previously done during an earlier lighting.
1. Locate the 3-position switch on the remote receiver
and slide the switch to the REMOTE position.
2. Locate the remote transmitter and press the ON button. The ignition
sequence will begin. The remote receiver will emit an audible “beep”;
then the igniter will begin to spark. After the pilot lights and is established,
the valve will automatically open and the burner will light.
Note:
The ignition sequence will take approximately 5 seconds.
WARNING: If the pilot fails to light or if the burner fails to light
(within 5 seconds of pilot lighting), press the OFF button on
the remote transmitter and/or slide the switch to the OFF
position. Allow five (5) minutes for any gas in the unit to
dissipate, then repeat steps 1 and 2 above.
IF YOU SMELL GAS, SEE STEP B ABOVE.
If the pilot fails to light after several tries, turn all control/remote system
components to OFF and contact a qualified professional service technician.
SHUTTING DOWN
For remote shut down,
press the
OFF
button on the remote transmitter.
If remote is unavailable
, slide the switch on the remote receiver to the
OFF
position.
PILOT APPEARANCE
Periodically check the pilot for proper flame pattern. The pilot flame should
encircle the generator tip, and is reset at the factory.
If the pilot flame burns incorrectly; shut down completely and contact a
qualified professional technician.
Electronic Pilot
